QUANZHOU YISHENG MACHINERY CO.,LTD Automechanika
Shanghai 2019
Hello, everyone. This is a joke about cars, let’s talk about cars together.
Recently, FAW-Volkswagen Co., Ltd. filed a recall plan with the State Administration for Market Regulation in accordance with the requirements of the 'Regulations on the Recall of Defective Automobile Products' and the 'Implementation Measures of the Regulations on the Recall of Defective Automobile Products.' It was decided to recall some imported and domestic Audi cars from February 26, 2021.
The details are as follows:
Recall models:
(1) Some domestic A6L 2.0T produced from April 25, 2018 to November 24, 2020 Vehicles, a total of 118,074;
quoted from the Autohome Gallery(2) Part of the imported A6 Avant 2.0T and A7 2.0T vehicles produced from October 14, 2019 to November 13, 2020, total 6724 vehicles.
Quoted from the Car Home GalleryRecall reason:
The vehicles within the recall range (1) and (2) are under certain operating conditions when the engine is idling. The imperfect learning function of the camshaft adjuster driving algorithm in the engine control unit may lead to deviations in the results, resulting in the camshaft not being adjusted to the correct position, which may cause the engine to run unsteadily, and the engine may stop running in extreme cases, posing a safety hazard.
Solution:
FAW-Volkswagen Automobile Co., Ltd. will entrust Audi authorized dealers to upgrade the engine control unit software for vehicles within the scope of the recall for free to eliminate potential safety hazards .
This recall was carried out when the State Administration for Market Regulation initiated a defect investigation. Affected by the investigation, FAW-Volkswagen Co., Ltd. decided to take recall measures to eliminate potential safety hazards.
Recall models:
(3) Part of the domestic Audi Q3 vehicles produced from September 25, 2019 to January 6, 2020, a total of 2 units.
Quoted from the Gallery of AutohomeReason for the recall:
Due to the manufacturer’s manufacturing reasons for the vehicles within the scope of this recall, the pulleys in the steering gear may have dimensional deviations, resulting in The circlip may not be installed correctly during assembly. In extreme cases, the circlip will fall off and jam the surrounding components, which will cause the steering system to lock up, posing a safety hazard.
Solution:
FAW-Volkswagen Automobile Co., Ltd. will entrust Audi authorized dealers to replace the steering gear assembly for vehicles within the scope of the recall free of charge to eliminate potential safety hazards.
I hope that you will check whether your car is in the scope of the recall and contact your local dealer as soon as possible.
Copyright © 2020 Quanzhou yisheng machinery co.,ltd. | All Rights Reserved